Toyota Car Stereo System 95 8211 User Manual

INSTALLATION INSTRUCTIONS FOR PART 95-8211  
APPLICATIONS  
Toyota Avalon  
2000-2004  
95-8211  
KIT FEATURES  
• Double DIN Radio Provision  
• Stacked ISO Mount Units Provision  
KIT COMPONENTS  
A) Double DIN Trim Plate  
A
TOOLS REQUIRED:  
Small Flat Blade Screwdriver • Panel Removal Tool  
• Phillips Screwdriver • Socket Set  
1-800-221-0932  
© COPYRIGHT 2004 METRA ELECTRONICS CORPORATION  
 
95-8211 DASH DISASSEMBLY  
TOYOTA AVALON 2000-2004 (column shift models)  
*Note: Refer also to the instructions included with the aftermarket radio.  
A
1
2
3
Disconnect the negative battery-  
terminal to prevent an accidental  
short circuit.  
Unsnap the trim below the cli-  
mate control to reveal (2) 10 MM  
bolts and remove. (Figure A)  
Carefully pull air vents above  
radio towards rear of car to  
unsnap. NOTE: There are (3)  
snaps, (2) are at the bottom sides  
and (1) is at the top middle of the  
vent assembly. (Figure B)  
B
4
5
Remove (2) 10 MM bolts from  
above radio/climate control  
assembly. Unplug and remove  
assembly together. (Figure C)  
Remove (6) Phillips screws (4  
from radio and 2 from climate  
control) from each side bracket to  
separate radio and climate con-  
trol. (Save climate controls and  
brackets to reuse during kit  
assembly). (Figure D)  
Continue to kit assembly.  
C
D
1
 
95-8211 DASH DISASSEMBLY  
TOYOTA AVALON 2000-2004 (console shift models)  
*Note: Refer also to the instructions included with the aftermarket radio.  
1
2
Disconnect the negative battery ter-  
minal to prevent an accidental short  
circuit.  
Open the center console armrest,  
unsnap cover above cup holder and  
remove (2) Phillips screws toward  
the outside of the panel. (Figure A)  
A
B
C
D
3
4
Lift up and remove shifter trim/ash-  
tray assembly. (Figure B)  
Unsnap black cover from under cli-  
mate controls and remove (2) 10  
MM bolts. (Figure C)  
5
Carefully pull air vents above radio  
towards rear of car to unsnap.  
NOTE: There are (3) snaps, (2) are  
at the bottom sides and (1) is at the  
top middle of the vent assembly.  
(Figure D)  
Remove (2) 10 MM bolts from above  
radio/climate control assembly.  
Unplug and remove assembly  
together. (Figure E)  
6
7
Remove (6) Phillips screws (4 from  
radio and 2 from climate control)  
from each side bracket to separate  
radio and climate control. (Save cli-  
mate controls and brackets to reuse  
during kit assembly). (Figure F)  
Continue to kit assembly.  
F
E
2
 
95-8211 KIT ASSEMBLY  
DOUBLE DIN RADIO PROVISION  
*Note: Refer also to the instructions included with the aftermarket radio.  
1
Attach the factory mounting brackets and the Double DIN trim plate to the Double  
DIN radio using the screws supplied with the radio. (Figure A)  
Continue to final assembly.  
A
3
 
95-8211 KIT ASSEMBLY  
STACKED ISO MOUNT UNITS PROVISION  
*Note: Refer also to the instructions included with the aftermarket radio.  
1
Attach the factory mounting brackets and the Double DIN trim plate to the  
stacked ISO Mount units using the screws supplied with the units. (Figure A)  
Continue to final assembly.  
A
4
 
95-8211 FINAL ASSEMBLY  
FINAL ASSEMBLY  
A
B
(A) Strip wire ends back 1/2"  
B) Twist ends together  
C) Solder  
D) Tape  
C
D
Locate the factory wiring harness in the dash. Metra recommends using the  
proper mating adapter and making connections as shown. (Isolate and individ-  
ually tape off the ends of any unused wires to prevent electrical short circuit.)  
1
2
3
Re-connect the negative battery terminal and test the unit for proper operation.  
Reassemble radio and dash assemblies in reverse order of disassembly.  
FINAL WIRING CONNECTIONS  
Make wiring connections using the EIA color code chart shown below and the instructions included with the  
head unit. Metra recommends making connections as shown below; Strip, Splice, Solder, Tape. Isolate and  
individually tape off ends of any unused wires to prevent electrical short circuit.  
METRA / EIA WIRING CODE  
12V Ignition / Acc. . . . . . . . . . Red  
Right Front (+) . . . . . . . . . . . . Gray  
12V Batt / Memory. . . . . . . . . Yellow  
Ground. . . . . . . . . . . . . . . . . . Black*  
Power Antenna. . . . . . . . . . . . Blue  
Right Front (-). . . . . . . . . . . . . Gray/ Black  
Left Front (+) . . . . . . . . . . . . . White  
Left Front (-). . . . . . . . . . . . . . White / Black  
Right Rear (+) . . . . . . . . . . . . Violet  
Amp Turn-On . . . . . . . . . . . . . Blue / White  
Amp Ground. . . . . . . . . . . . . . Black / White  
Illumination . . . . . . . . . . . . . . Orange  
Dimmer . . . . . . . . . . . . . . . . . Orange / White  
Right Rear (-) . . . . . . . . . . . . . Violet / Black  
Left Rear (+) . . . . . . . . . . . . . Green  
Left Rear (-) . . . . . . . . . . . . . . Green / Black  
*NOTE: When a Black wire is not present, ground radio to vehicle chassis.  
All colors may not be present on all leads due to manufacturer’s specifications.  
5
 
95-8211 INSTRUCTIONS  
1-800-221-0932  
REV. 01/03/07 © COPYRIGHT 2004 METRA ELECTRONICS CORPORATION  
INST95-8211  
 

TechniSat Satellite Radio VC 2002 S User Manual
Toshiba Printer B 480 QQ User Manual
Toshiba Telephone IP5000 UG VC User Manual
Transition Networks Network Card E CX MC02 User Manual
Tricity Bendix Oven BS 615 SO User Manual
Uniden Cordless Telephone X24GHz User Manual
United States Pumice Company Griddle WG 2424G User Manual
Verilux Indoor Furnishings VD07 User Manual
Vinotemp Refrigerator VINO2500SSH User Manual
Vivitek Projector D5180HD User Manual